Then follow the procedure on the site to install it on the SD card and set it up. Change the material in the Maintenance menu to Customized and set up an alternate PLA setting. Remove the setting from config-override before making changes in config.txtĪs we can no longer control the printer through Wifi, I have chosen to control it with OctoPrint. First, lower the temp to 200c, or even 195.The setting in the config.txt file is _per_mm. I used the procedure described here to calibrate my extruder. This writes the setting in the config-override file. Store new zero location permanently (M500).Use the controls in either printer control or repetier-host to lower the nozzle so that you can pass a piece of paper between nozzle and bed without the nozzle catching it.Move nozzle to middle of plate at 10mm above zero (G1 X90 Y90 Z10). Open the serial port to communicate directly to the printer and do: I found the nozzle height in Cetus Studio not to be correct when starting to print with the tinyFab CPU, so I followed this procedure to set it correctlyĬonnect the printer through USB to either Simplify 3D printer control or repetier-host. Unmount the drive and restart the printer.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |